Tilt Finish 20LBS
Mapei
#14720
Mapei Tilt Finish is a professional finishing compound for concrete surfaces. Tilt Finish is a versatile, fast-setting, polymer-modified material blending calcium aluminate and Portland cement. Tilt Finish is ideal for producing a smooth finish on concrete surfaces including tilt wall, poured-in-place concrete, masonry, pre-cast beams and columns. Ease of placement makes it ideal for covering imperfections in concrete surfaces, providing a uniform, light gray appearance, or a smooth surface before painting or application of coating. Sold by the bag.
Tilt Finish features extraordinary ease of placement, with a variable water ratio, extended pot life and outstanding workability. Light gray Tilt Finish can be applied from featheredge, up to 1/2" (12 mm) in confined areas and up to 1/8" (3 mm) over large surface areas.
- Tilt Finish is natural light gray and can be used as final surface.
- Tilt Finish can be installed from featheredge to 1/8" (3 mm) over large surface areas and up to 1/2" (12 mm) in confined areas (< 2 sq. in. [13 cm2]). When placing Tilt Finish in deeper voids, use the minimum specified water ratio. Use Planitop® X or Planitop XS for repairs deeper than 1/2" (12 mm) and cover with Tilt Finish.
- Tilt Finish can be primed, sealed, painted or covered with coatings in as
little as 24 hours, depending on temperature. - Tilt Finish can be colored with iron oxide pigments and liquid color packs. Verify compatibility before use.
- Tilt Finish is compatible with most coatings, paints, sealers, dyes and concrete stains.
- Tilt Finish can be used for exterior concrete repairs and has good resistance to freeze/thaw cycles. For enhanced durability, ensure Tilt Finish is painted or sealed in extreme freeze/thaw environments.
- Tilt Finish can be applied from 41°F to 95°F (5°C to 35°C). Allow for extra cure time when temperatures are below 65°F (18°C). Follow ACI guidelines when installing at above 85°F (29°C).
- Smoothing/finishing compound for tilt-wall systems
- Patching of poured-in-place concrete
- Smoothing of pre-cast beams and columns
- Smoothing of masonry surfaces
- Refinishing and patching of concrete surfaces where concrete’s natural gray color is desired
- Sound, stable, clean, vertical and overhead exterior concrete surfaces free of hydrostatic pressure
- Masonry and block surfaces
- Properly prepared interior horizontal and vertical surfaces
See Technical Information for More Details and Application Instructions.
